Lightly dampen a fresh, clean, lint-free cloth with bottled or distilled water.Ĭlean the electrical contacts inside the printer by wiping them from top to bottom. Wipe away from the nozzles only.ĭry the previously cleaned areas with a clean, dry, lint-free cloth. Use a fresh, lightly dampened, lint-free cloth to wipe the plastic ramps on both sides of the ink nozzles. Use a fresh, lightly dampened, lint-free cloth to wipe any accumulated ink and debris from the edge between the ink nozzles and the electrical contacts.įigure : Clean the edge between the ink nozzles and the electrical contacts Repeat this motion until no ink appears on the cloth. Do not go past the edge between the electrical contacts and the ink nozzles. Use the damp cloth to wipe the electrical contacts from the bottom to the top. Tap water can contain contaminants that can damage the printhead. Coffee filters and glass-cleaning cloths work well.ĭistilled or bottled water. Several clean, lint-free cloths or papers. Do not touch the electrical contacts with your finger.įigure : Do not touch the contact area with your fingersįollow these steps to clean the printhead. Plastic ramps on the sides of the nozzlesĭo not touch the ink nozzles. There are three areas on the printhead that need to be cleaned: the plastic ramps on both sides of the ink nozzles, the edge between the ink nozzles and the electrical contacts, and the electrical contacts.įigure : The three areas on the printhead that need to be cleaned Lift the printhead to remove it from the carriage. Lift the latch handle on the carriage until it stops. To remove a cartridge, press the tab on the front of the cartridge and then pull it up to remove it from its slot. This could result in damage to both the printer and the cartridges. CAUTION:ĭo not leave the cartridges outside of the printer longer than 30 minutes. Remove all of the cartridges, and then place them on a piece of paper with the ink nozzles pointing up. Wait until the carriage is idle and silent before continuing. The carriage moves to the center of the printer. Press the Power button to turn on the printer, if it is not already turned on. Step 1: Remove the cartridges and printhead
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |